Friday 11 November 2016

More frustrations from a different source.

A slightly frustrating visit to the club on the 22nd of October.

On my previous visit we had managed to get power to the whole of the layout including Brookes sidings but then discovered that we had a short somewhere on the end board (the one with most of Brookes sidings).

At an intermediate visit someone had tried to find the source of the short by cutting the feeds to the sidings from the buss bars. However, some of the main line feeds had also been cut and some of the siding feeds had been missed.

So, this time some careful work with the multimeter, showed that the main line was not the source of the short, and in fact showed that one piece of rail on the main wasn’t linked electrically to its neighbours by the thin copper wires that are soldered to the side of each rail joint.

Therefore the main was re-connected fully and the rest of the sidings were disconnected from the main line buss bars.

Then a new pair of buss bars were installed for Brookes sidings. (hmm, do we need some for the goods yard? and does the goods yard have sufficient droppers to maintain reliability?).

Nothing has been connected to the Brookes buss bars as the rest of the afternoon was taken up with methodically searching for the short with the multimeter.
This was eventually narrowed down to the area of the outermost 'Brookes' siding and the point that leads to it. The rest of Brookes sidings seem to be fine. Hopefully we'll be able to pin-point the short soon.
I think the next step will be to un-solder the switch for the frog to eliminate that & then examine the sleeper insulating gaps. Must remember my big iron next visit.

Sam.

No comments:

Post a Comment